Toyota Fortuner cranking but not starting
On a Toyota Fortuner, this usually comes down to carburettor flooding or blocked jets or diesel glow plugs or air in the fuel. Below are the causes that fit this car, most likely first, and what fixes each one.
Why a Toyota Fortuner is cranking but not starting
3.0 L 1KD-FTV turbo diesel · 2.8 L 1GD-FTV turbo diesel · 2.7 L 2TR-FE petrol
| Likely cause | How likely | The fix |
|---|---|---|
Carburettor flooding or blocked jetsFits the Fortuner On carburetted engines, a sticking float floods the engine and dirt blocks the jets. A strong petrol smell and wet plugs point to flooding. | Common | Carburetor repair |
Diesel glow plugs or air in the fuelFits the Fortuner A diesel relies on compression heat and, when cold, glow plugs. Failed glow plugs or air drawn into the fuel line after a filter change prevent firing. | Common | Fuel filter service |
Failed fuel pump or blocked fuel filter No pump hum at key-on, or low pressure on a gauge, means fuel is not reaching the injectors. Poor-quality fuel and sediment in tanks speed up pump and filter wear. | Common | Fuel pump replacement |
Ignition fault: coil, plugs or crank sensor A failed crankshaft position sensor stops both spark and injection on most modern engines. A spark tester and a scan for crank signal confirm it. | Common | Engine diagnosis |
Immobiliser not recognising the key The engine cranks but the computer blocks fuel. A flashing security light and an immobiliser code on the scanner confirm it. | Possible | Ecu diagnostics |
Causes marked “Fits the Fortuner” apply because of how this car is built: its diesel/petrol engine, MANUAL/AUTOMATIC gearbox, timing chain.
General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.
Can you keep driving?
It will not drive until it starts. Do not keep cranking for long spells, as this floods the engine and can damage the catalytic converter. If the timing belt has snapped, cranking can make internal damage worse.
Checks you can do first
- Check the fuel gauge, and do not trust it fully if the car has been near empty.
- Turn the key to ON without cranking and listen for a brief hum from the fuel pump under the rear seat.
- Look for a flashing key or immobiliser light on the dashboard.
- On a CNG car, switch to petrol and try again to see if the fault follows the fuel.
How a technician diagnoses it on a Fortuner
Step 1
Scan for codes and watch live data for engine speed signal while cranking.
Step 2
Fit a fuel pressure gauge and compare with the specification.
Step 3
Check for spark at each cylinder with a spark tester.
Step 4
Confirm the camshaft turns with the crank to rule out a broken timing belt or jumped chain.
Other Toyota Fortuner problems
- Fortuner blowing black smokeWidely reported on this model
- Fortuner using too much fuelWidely reported on this model
- Fortuner hard to start (diesel)Widely reported on this model
- Fortuner losing turbo boostWidely reported on this model
- Fortuner not starting
- Fortuner showing a check engine light
- Fortuner squeaking when braking
- Fortuner having a soft brake pedal
- Fortuner vibrating through the steering wheel
Parts usually involved
Get your Fortuner looked at
Tell us the Toyota Fortuner, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.
Before you book
Questions we get asked
If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.



