Mitsubishi eK Wagon showing the ABS warning light
On a Mitsubishi eK Wagon, this usually comes down to dirty or damaged reluctor ring or rear sensors on 4x4 or rear-drive axles. Below are the causes that fit this car, most likely first, and what fixes each one.
Why a Mitsubishi eK Wagon is showing the ABS warning light
660 cc 3B20 petrol · 660 cc BR06 petrol
| Likely cause | How likely | The fix |
|---|---|---|
Dirty or damaged reluctor ringFits the eK Wagon The toothed ring the sensor reads can rust or crack, giving an erratic signal. It is seen on inspection with the wheel off. | Possible | Abs repair |
Rear sensors on 4x4 or rear-drive axlesFits the eK Wagon On solid rear axles and 4x4s, the rear sensor sits in the differential or axle housing where mud and water collect. Inspection and live data confirm it. | Possible | Abs repair |
Faulty wheel speed sensor A sensor that stops giving a signal disables ABS. A scan names the wheel, and live data shows the dead reading. | Common | Abs repair |
Damaged sensor wiring or connector Wires near the wheels get chafed by stones and corroded by water. Continuity tests and inspection find the break. | Common | Wiring repair |
Worn wheel bearing with built-in sensor ring On many newer cars the magnetic encoder sits in the wheel bearing; play or damage disturbs the signal. Bearing play and noise confirm it. | Possible | Wheel bearing replacement |
Low brake fluid Some systems share the warning between ABS and fluid level. The reservoir level and pad wear tell the story. | Possible | Brake fluid change |
Low system voltage A weak battery or charging fault can make the ABS module log low-voltage faults. Battery and charging tests confirm it. | Possible | Charging system inspection |
Causes marked “Fits the eK Wagon” apply because of how this car is built: its petrol engine, CVT gearbox, timing chain.
General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.
Can you keep driving?
With only the amber ABS light, the brakes work normally but without anti-lock, so leave extra distance, especially on wet roads. If the red brake warning is on too, or the pedal feels wrong, stop and have it checked before driving.
Checks you can do first
- Check whether the red brake warning light is also on.
- Check the brake fluid level in the reservoir.
- Look behind each wheel for a torn or hanging sensor wire, especially after rough roads or a puncture repair.
- Note if the light came on after washing the car or driving through deep water.
How a technician diagnoses it on a eK Wagon
Step 1
Read ABS codes and live wheel speed data on a road test.
Step 2
Inspect sensors, wiring and connectors at the indicated wheel.
Step 3
Check the reluctor ring or bearing encoder and bearing play.
Step 4
Check battery voltage and brake fluid level.
Other Mitsubishi eK Wagon problems
- eK Wagon AC not coolingWidely reported on this model
- eK Wagon juddering or whining from the CVTWidely reported on this model
- eK Wagon vibrating at idleWidely reported on this model
- eK Wagon vibrating through the steering wheel
- eK Wagon clicking when turning
- eK Wagon humming at speed
- eK Wagon with uneven tyre wear
- eK Wagon with a timing chain rattle
Parts usually involved
ABS warning light on other cars
Get your eK Wagon looked at
Tell us the Mitsubishi eK Wagon, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.
Before you book
Questions we get asked
If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.



