Mitsubishi Lancer having trouble starting on CNG
CNG-converted Lancers often suffer hard starting or stalling on gas because of old kits and worn plugs. Below are the causes that fit a Mitsubishi Lancer, most likely first, and what fixes each one.
Why a Mitsubishi Lancer is having trouble starting on CNG
1.3 L petrol · 1.6 L petrol
| Likely cause | How likely | The fix |
|---|---|---|
Weak spark plugsFits the Lancer CNG needs higher ignition energy; worn plugs fail to light it. Plug inspection confirms it. | Common | Spark plug replacement |
Faulty reducer or solenoidFits the Lancer A worn reducer or sticking solenoid gives too little or too much gas. Kit inspection confirms it. | Common | Cng kit inspection |
Poor kit tuningFits the Lancer Wrong mixer or timing settings cause hard starts. Tuning restores it. | Common | Cng kit inspection |
Weak ignition coilsFits the Lancer Coils that work on petrol can fail under CNG load. Coil testing confirms it. | Possible | Ignition coil replacement |
Cold weather start on gasFits the Lancer Cold reducers struggle in winter; starting on petrol avoids it. Reducer coolant hoses are checked. | Possible | Cng kit inspection |
Low compression on older enginesFits the Lancer Worn engines lose compression and struggle more on CNG. Compression tests confirm it. | Possible | Engine diagnosis |
Weak battery Slow cranking is harder on CNG. Battery testing confirms it. | Possible | Battery testing |
Causes marked “Fits the Lancer” apply because of how this car is built: its petrol engine, MANUAL/AUTOMATIC gearbox, timing belt or a CNG conversion.
General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.
Can you keep driving?
Usually yes on petrol. If you smell gas, close the cylinder valve and do not drive until checked.
Checks you can do first
- Check cylinder pressure gauge.
- Try starting on petrol and switching to CNG once warm.
- Smell for gas leaks around the kit.
How a technician diagnoses it on a Lancer
Step 1
Inspect spark plugs and coils.
Step 2
Check reducer, solenoid and pressures.
Step 3
Test compression and battery.
Step 4
Retune the kit if needed.
Other Mitsubishi Lancer problems
- Lancer overheatingWidely reported on this model
- Lancer knocking from the suspensionWidely reported on this model
- Lancer leaking oilWidely reported on this model
- Lancer not starting
- Lancer cranking but not starting
- Lancer showing a check engine light
- Lancer vibrating through the steering wheel
- Lancer misfiring
- Lancer blowing blue smoke
Parts usually involved
CNG starting problems on other cars
Get your Lancer looked at
Tell us the Mitsubishi Lancer, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.
Before you book
Questions we get asked
If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.



