Daihatsu Mira misfiring
On a Daihatsu Mira, this usually comes down to worn distributor cap, rotor or high-tension leads or valve clearance too tight. Below are the causes that fit this car, most likely first, and what fixes each one.
Why a Daihatsu Mira is misfiring
0.66 L KF three-cylinder petrol
| Likely cause | How likely | The fix |
|---|---|---|
Worn distributor cap, rotor or high-tension leadsFits the Mira Older cars with a distributor lose spark through cracked caps and leads, especially in damp weather. Visual inspection and resistance tests find it. | Common | Tune up |
Valve clearance too tightFits the Mira Engines with adjustable tappets, common on older and small engines, need periodic valve adjustment; tight clearances cause misfire and burnt valves. | Possible | Valve adjustment |
Worn spark plugs Worn electrodes need more voltage to spark and fail under load. Inspecting the plugs shows wear or fouling. | Common | Spark plug replacement |
Failing ignition coil Heat cracks coil insulation. Swapping coils between cylinders and seeing the misfire follow confirms it. | Common | Ignition coil replacement |
Clogged or leaking injector Dirty fuel blocks injectors and leaves a cylinder lean. Injector balance and spray tests confirm it. | Possible | Fuel injector service |
Vacuum leak A cracked hose lets in unmetered air, causing lean misfire at idle. A smoke test finds it. | Possible | Engine diagnosis |
Low compression or burnt valve A worn valve or ring leaves one cylinder short of compression. A compression or leak-down test confirms it. | Less common | Engine repair |
Causes marked “Fits the Mira” apply because of how this car is built: its petrol engine, CVT/AUTOMATIC gearbox, timing chain.
General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.
Can you keep driving?
Short, gentle trips are usually possible with a mild misfire. If the check engine light flashes, drive as little as possible and avoid heavy load until it is repaired.
Checks you can do first
- Note whether the shaking is at idle, under load, or both.
- Check whether the check engine light is steady or flashing.
- Note whether it happens only on CNG or only on petrol.
- Check whether it started after washing the engine or driving through water.
How a technician diagnoses it on a Mira
Step 1
Read misfire codes and per-cylinder misfire counters.
Step 2
Swap coils and plugs between cylinders to see if the misfire moves.
Step 3
Test injectors and check for vacuum leaks.
Step 4
Run a compression test if ignition and fuel are fine.
Other Daihatsu Mira problems
- Mira AC not coolingWidely reported on this model
- Mira draining its batteryWidely reported on this model
- Mira juddering or whining from the CVTWidely reported on this model
- Mira vibrating at idleWidely reported on this model
- Mira not starting
- Mira vibrating through the steering wheel
- Mira knocking from the suspension
- Mira using too much fuel
- Mira leaking oil
Parts usually involved
Engine misfire on other cars
Get your Mira looked at
Tell us the Daihatsu Mira, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.
Before you book
Questions we get asked
If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.



