Nissan Clipper clicking when turning
On a Nissan Clipper, this usually comes down to worn outer cv joint or split cv boot with dust entry. Below are the causes that fit this car, most likely first, and what fixes each one.
Why a Nissan Clipper is clicking when turning
0.66 L Mitsubishi 3G83 petrol (2003–2013) · 0.66 L Suzuki K6A / R06A petrol (2013–present)
| Likely cause | How likely | The fix |
|---|---|---|
Worn outer CV jointFits the Clipper Wear in the joint makes it click under load when turning. A torn boot and play confirm it. | Common | Cv joint replacement |
Split CV boot with dust entryFits the Clipper Dust and monsoon water enter a split boot and destroy the joint. Inspection shows grease spray. | Common | Cv joint replacement |
Front hub or free-wheel hub on 4x4Fits the Clipper 4x4 front hubs and driveshaft joints click when engaged or worn. Inspection in 4WD confirms it. | Possible | Differential repair |
Worn stabilizer links Loose links knock or click over bumps while turning. Shaking the link shows play. | Possible | Stabilizer link replacement |
Strut top mount or bearing A dry strut bearing clicks or creaks while steering. Feeling the strut while turning confirms it. | Possible | Strut replacement |
Tie rod end or ball joint play Worn steering joints click as load shifts. Play checks with the car lifted confirm it. | Possible | Tie rod replacement |
Causes marked “Fits the Clipper” apply because of how this car is built: its petrol engine, MANUAL/AUTOMATIC/AGS gearbox, timing chain.
General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.
Can you keep driving?
You can usually drive with care for a short time, but avoid sharp full-lock turns. If clicking becomes clunking or the car stops moving, stop.
Checks you can do first
- Turn on full lock slowly in an open area and listen for which side clicks.
- Look behind the front wheels for grease splashed around or a torn boot.
- Note if clicking is in reverse as well.
How a technician diagnoses it on a Clipper
Step 1
Road test at full lock both ways to identify side.
Step 2
Inspect CV boots and joints for play.
Step 3
Check links, joints and strut mounts.
Step 4
On 4x4s, test with 4WD engaged and disengaged.
Other Nissan Clipper problems
- Clipper overheatingWidely reported on this model
- Clipper knocking from the suspensionWidely reported on this model
- Clipper having AGS gearbox problemsWidely reported on this model
- Clipper not starting
- Clipper pulling to one side
- Clipper vibrating through the steering wheel
- Clipper using too much fuel
- Clipper leaking oil
- Clipper draining its battery
Parts usually involved
Get your Clipper looked at
Tell us the Nissan Clipper, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.
Before you book
Questions we get asked
If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.



