Nissan Clipper with power windows not working
On a Nissan Clipper, this usually comes down to broken wiring in the door hinge or window not initialised after battery change. Below are the causes that fit this car, most likely first, and what fixes each one.
Why a Nissan Clipper is with power windows not working
0.66 L Mitsubishi 3G83 petrol (2003–2013) · 0.66 L Suzuki K6A / R06A petrol (2013–present)
| Likely cause | How likely | The fix |
|---|---|---|
Broken wiring in the door hingeFits the Clipper Wires flexing at the hinge crack over years. Continuity tests confirm it. | Possible | Wiring repair |
Window not initialised after battery changeFits the Clipper Many imported cars need auto-up/down reset after battery disconnection. Following the reset procedure fixes it. | Possible | Power window repair |
Faulty window switch Dust and spilled drinks damage switches. Testing from another switch helps isolate it. | Common | Power window repair |
Worn window motor Motors slow and fail with age. Voltage at the motor confirms whether it is getting power. | Common | Power window repair |
Broken regulator cable Cable regulators snap and the glass drops. Grinding noise points to it. | Common | Power window repair |
Blown fuse or relay A short or overload blows a fuse. Fuse checks confirm it. | Possible | Fuse relay replacement |
Water damage in door Monsoon water entering through damaged seals corrodes switches and motors. Inspection shows corrosion. | Possible | Power window repair |
Causes marked “Fits the Clipper” apply because of how this car is built: its petrol engine, MANUAL/AUTOMATIC/AGS gearbox, timing chain.
General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.
Can you keep driving?
Yes. If a window is stuck open, cover it and keep valuables out of sight until repaired.
Checks you can do first
- Try the window from both the driver and passenger switches.
- Listen for the motor running when you press the switch.
- Check the window lock button is off.
- Check the fuse.
How a technician diagnoses it on a Clipper
Step 1
Check fuse, switch operation and voltage at motor.
Step 2
Remove door trim to inspect motor and regulator.
Step 3
Test door hinge wiring.
Other Nissan Clipper problems
- Clipper overheatingWidely reported on this model
- Clipper knocking from the suspensionWidely reported on this model
- Clipper having AGS gearbox problemsWidely reported on this model
- Clipper not starting
- Clipper pulling to one side
- Clipper vibrating through the steering wheel
- Clipper using too much fuel
- Clipper leaking oil
- Clipper draining its battery
Power windows not working on other cars
Get your Clipper looked at
Tell us the Nissan Clipper, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.
Before you book
Questions we get asked
If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.



