Mitsubishi Lancer showing the airbag warning light
On a Mitsubishi Lancer, this usually comes down to worn clock spring or deployed or removed parts after an accident. Below are the causes that fit this car, most likely first, and what fixes each one.
Why a Mitsubishi Lancer is showing the airbag warning light
1.3 L petrol · 1.6 L petrol
| Likely cause | How likely | The fix |
|---|---|---|
Worn clock springFits the Lancer The ribbon cable behind the steering wheel breaks after many turns, often with horn failure. Codes for the driver airbag circuit confirm it. | Common | Abs airbag diagnosis |
Deployed or removed parts after an accidentFits the Lancer Imported or repaired cars sometimes have airbags or modules not properly replaced. Crash data stored in the module and inspection reveal it. | Possible | Accident repair |
Fitted seat covers blocking side airbagsFits the Lancer Seats with side airbags need compatible covers; some covers also disturb occupant sensors. Inspection and codes confirm it. | Possible | Abs airbag diagnosis |
Loose seat or seatbelt connector Connectors under the front seats get pulled when seats move or are removed for cleaning. The scan shows a high-resistance fault in that circuit. | Common | Abs airbag diagnosis |
Faulty crash sensor or wiring Front crash sensors sit low in the bumper area and suffer from water and minor knocks. Circuit tests locate the fault. | Possible | Wiring repair |
Low battery voltage during cranking A weak battery can log temporary SRS faults. They return as history codes and clear once the battery is sorted. | Less common | Battery testing |
SRS control module fault A module that has stored crash data or failed internally keeps the light on. Scan tools show module-internal codes. | Less common | Ecu repair |
Causes marked “Fits the Lancer” apply because of how this car is built: its petrol engine, MANUAL/AUTOMATIC gearbox, timing belt or a CNG conversion.
General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.
Can you keep driving?
The car will drive, but you should assume the airbags will not work in a collision. Get it diagnosed soon and do not try to remove airbag parts yourself.
Checks you can do first
- Note whether the horn or steering buttons also stopped working, which points to the clock spring.
- Check whether the light came on after a seat was moved, removed or a seat cover fitted.
- Ask whether the car has had accident repair or a steering wheel change.
- Do not unplug yellow SRS connectors yourself.
How a technician diagnoses it on a Lancer
Step 1
Read SRS codes with a scanner that supports the airbag module.
Step 2
Disconnect the battery and wait as the manual specifies before touching SRS parts.
Step 3
Check seat, seatbelt and clock spring circuits for resistance faults.
Step 4
Inspect crash sensors and harnesses, then clear codes and confirm the light stays off.
Other Mitsubishi Lancer problems
- Lancer overheatingWidely reported on this model
- Lancer knocking from the suspensionWidely reported on this model
- Lancer leaking oilWidely reported on this model
- Lancer having trouble starting on CNGWidely reported on this model
- Lancer not starting
- Lancer cranking but not starting
- Lancer showing a check engine light
- Lancer vibrating through the steering wheel
- Lancer misfiring
Airbag warning light on other cars
Get your Lancer looked at
Tell us the Mitsubishi Lancer, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.
Before you book
Questions we get asked
If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.



