Suzuki Bolan grinding when braking
On a Suzuki Bolan, this usually comes down to rear brake shoes worn out or heavy-vehicle brake wear. Below are the causes that fit this car, most likely first, and what fixes each one.
Why a Suzuki Bolan is grinding when braking
0.8 L F8B three-cylinder petrol
| Likely cause | How likely | The fix |
|---|---|---|
Rear brake shoes worn outFits the Bolan Drum brakes on many local cars wear their shoes until rivets touch the drum. Drum removal shows it. | Common | Brake drum service |
Heavy-vehicle brake wearFits the Bolan Pickups, vans and SUVs carrying loads wear brakes faster. Inspection shows rapid pad and shoe wear. | Possible | Brake pad replacement |
Pads worn to the backing plate Once the friction material is gone, steel scrapes the disc. Inspection shows no pad left. | Common | Brake pad replacement |
Stone or debris between pad and disc Gravel lodges by the backing plate, grinding constantly. Removing the wheel finds it. | Possible | Brake noise diagnosis |
Seized caliper A stuck caliper wears one pad unevenly to metal. Comparing pads side to side confirms it. | Possible | Brake caliper repair |
Rusted discs after standing or monsoon Surface rust grinds briefly after rain or parking; heavy pitting needs disc replacement. Inspection shows how deep it goes. | Possible | Brake disc replacement |
Worn wheel bearing A rough bearing can grind more under braking load. Wheel play and spin tests confirm it. | Less common | Wheel bearing replacement |
Causes marked “Fits the Bolan” apply because of how this car is built: its petrol engine, MANUAL gearbox, timing belt or a CNG conversion.
General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.
Can you keep driving?
Only as far as a workshop, slowly and with extra distance. Metal-on-metal brakes can fail to stop the car in time.
Checks you can do first
- Look through the wheel spokes at pad thickness and disc surface.
- Note whether grinding is from the front or rear.
- Check for grooves or a raised lip on the disc edge.
- Note whether the noise happens only after rain or washing.
How a technician diagnoses it on a Bolan
Step 1
Remove wheels and measure pad, shoe and disc thickness.
Step 2
Check calipers for sticking and pads for uneven wear.
Step 3
Inspect drums and wheel bearings.
Step 4
Road test after repair to confirm quiet braking.
Other Suzuki Bolan problems
- Bolan overheatingWidely reported on this model
- Bolan having a soft brake pedalWidely reported on this model
- Bolan slipping its clutchWidely reported on this model
- Bolan having trouble starting on CNGWidely reported on this model
- Bolan cranking but not starting
- Bolan squeaking when braking
- Bolan pulling to one side
- Bolan knocking from the suspension
- Bolan misfiring
Parts usually involved
Grinding noise when braking on other cars
Get your Bolan looked at
Tell us the Suzuki Bolan, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.
Before you book
Questions we get asked
If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.



