Islamabad Car Mechanic — Doorstep & Workshop Auto Repair Services

Honda City misfiring

On the twin-plug i-DSI engine, a worn plug or coil causes rough running, especially on CNG. Below are the causes that fit a Honda City, most likely first, and what fixes each one.

Why a Honda City is misfiring

1.3 L L13A i-DSI petrol · 1.3 L L13 i-VTEC petrol · 1.5 L L15 i-VTEC petrol

Likely causeHow likelyThe fix

CNG wears plugs and coils fasterFits the City

Gas needs a stronger spark than petrol, so plugs and coils wear out sooner and misfire first on CNG. Using the right plug gap for gas helps.

CommonCng kit inspection

Worn distributor cap, rotor or high-tension leadsFits the City

Older cars with a distributor lose spark through cracked caps and leads, especially in damp weather. Visual inspection and resistance tests find it.

CommonTune up

Worn spark plugs

Worn electrodes need more voltage to spark and fail under load. Inspecting the plugs shows wear or fouling.

CommonSpark plug replacement

Failing ignition coil

Heat cracks coil insulation. Swapping coils between cylinders and seeing the misfire follow confirms it.

CommonIgnition coil replacement

Clogged or leaking injector

Dirty fuel blocks injectors and leaves a cylinder lean. Injector balance and spray tests confirm it.

PossibleFuel injector service

Vacuum leak

A cracked hose lets in unmetered air, causing lean misfire at idle. A smoke test finds it.

PossibleEngine diagnosis

Low compression or burnt valve

A worn valve or ring leaves one cylinder short of compression. A compression or leak-down test confirms it.

Less commonEngine repair

Causes marked “Fits the City” apply because of how this car is built: its petrol engine, MANUAL/AUTOMATIC/CVT gearbox, timing chain or a CNG conversion.

General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.

Can you keep driving?

Short, gentle trips are usually possible with a mild misfire. If the check engine light flashes, drive as little as possible and avoid heavy load until it is repaired.

Checks you can do first

  • Note whether the shaking is at idle, under load, or both.
  • Check whether the check engine light is steady or flashing.
  • Note whether it happens only on CNG or only on petrol.
  • Check whether it started after washing the engine or driving through water.

How a technician diagnoses it on a City

  1. Step 1

    Read misfire codes and per-cylinder misfire counters.

  2. Step 2

    Swap coils and plugs between cylinders to see if the misfire moves.

  3. Step 3

    Test injectors and check for vacuum leaks.

  4. Step 4

    Run a compression test if ignition and fuel are fine.

Get your City looked at

Tell us the Honda City, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.

  1. 1
  2. 2
  3. 3

No payment now. We confirm the price before work starts.

Before you book

Questions we get asked

If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.

Chat on WhatsAppBook a Mechanic