Mitsubishi Lancer using too much fuel
On a Mitsubishi Lancer, this usually comes down to out-of-tune carburettor or old or slipping automatic transmission. Below are the causes that fit this car, most likely first, and what fixes each one.
Why a Mitsubishi Lancer is using too much fuel
1.3 L petrol · 1.6 L petrol
| Likely cause | How likely | The fix |
|---|---|---|
Out-of-tune carburettorFits the Lancer Older carburetted cars lose economy as jets wear. Cleaning and tuning restores it. | Common | Carburetor repair |
Old or slipping automatic transmissionFits the Lancer Old fluid or worn clutches in an automatic waste power. Fluid condition and slip in live data show it. | Possible | Transmission oil change |
Petrol use higher after CNG conversionFits the Lancer A converted car running on petrol with a poorly set emulator can use more petrol than before. Checking the kit settings confirms it. | Possible | Cng kit inspection |
Low tyre pressure Soft tyres increase rolling resistance. Checking pressures is quick and free. | Common | Puncture repair |
Dirty air filter or worn plugs A clogged filter or weak spark wastes fuel. A tune-up checks both. | Common | Tune up |
Faulty oxygen sensor or thermostat A lazy oxygen sensor or a thermostat stuck open keeps the engine running rich. Live data shows it. | Possible | Sensor testing |
Dragging brakes A sticking caliper or tight handbrake acts like a constant load. A hot wheel points to it. | Possible | Brake caliper repair |
Causes marked “Fits the Lancer” apply because of how this car is built: its petrol engine, MANUAL/AUTOMATIC gearbox, timing belt or a CNG conversion.
General guidance based on how these cars are built and how they commonly wear. Your car’s own history matters more than any list, which is why a technician confirms the cause before quoting.
Can you keep driving?
Yes. Note any other symptoms, such as smoke, misfires or warning lights, and mention them when you get it checked.
Checks you can do first
- Measure consumption over two full tanks with the same driving.
- Check tyre pressures when cold.
- Check the air filter.
- Remove unneeded weight from the boot.
How a technician diagnoses it on a Lancer
Step 1
Confirm consumption with a measured fill-to-fill test.
Step 2
Scan for codes and review fuel trims and coolant temperature.
Step 3
Check brakes for drag and tyres for pressure.
Step 4
On hybrids, check battery state and engine run time.
Other Mitsubishi Lancer problems
- Lancer overheatingWidely reported on this model
- Lancer knocking from the suspensionWidely reported on this model
- Lancer leaking oilWidely reported on this model
- Lancer having trouble starting on CNGWidely reported on this model
- Lancer not starting
- Lancer cranking but not starting
- Lancer showing a check engine light
- Lancer vibrating through the steering wheel
- Lancer misfiring
Parts usually involved
High fuel consumption on other cars
Get your Lancer looked at
Tell us the Mitsubishi Lancer, the symptom and where the car is. A person calls back to say what we can do in your city and what the diagnosis costs.
Before you book
Questions we get asked
If your question is not here, ask it. We would rather answer honestly now than have you find out after booking.



